Subject	Had the same issue. The UD pulley is quite a bit thicker
Posted by	Evan_Wright (Ca) on July 12, 2013 at 2:49 PM
	This message has been viewed 152 times.
In Reply To	Anyone running UD pulleys bothered by what little engagement posted by Jayru on July 12, 2013 at 01:47 PM
Message	then the H.I. or oem pulley. I can't remember if I got them from autozone or oreilys but I found some studs that were a few mm's longer. I wouldn't run that pulley without full thread engagement. I didn't have any issues with the fan contacting the shroud though.
Follow Ups	Anyone running UD pulleys bothered by what little engagement - Jayru 13:47:18 07/12/13 Had the same issue. The UD pulley is quite a bit thicker - Evan_Wright (Ca) 14:49:08 07/12/13 I have a U.D. pully on mine that I purchaced in 2003. - z32z 15:41:27 07/12/13 I'd swap the studs with longer, and def loctite - jkperformance 19:45:26 07/12/13 The HI v2 pulley does not have this issue. (n/m) - Bernie (NoVA) 00:30:13 07/16/13
Post a Followup	You cannot reply to this message because you are not logged in.