Subject	Thanks Gordo 93TT, your advice worked >>
Posted by	stockplayerz(nyc) on July 11, 2013 at 9:05 PM
	This message has been viewed 259 times.
Message	in finding water leak. Pressurized radiator and instantly found water spewing out from one of two hoses going into block from front, where the coolant temp sensor attaches. right side one. Is there a writeup on how to replace this hose? Can this be done without removing radiator, timing cover, fan, etc? How long would it take to do? Thanks! Mike
Follow Ups	Thanks Gordo 93TT, your advice worked >> - stockplayerz(nyc) 21:05:56 07/11/13 coolant bypass hose I think. you could do it without the - LivinTheDream 21:21:45 07/11/13 From looking at the FSM >> - stockplayerz(nyc) 21:43:37 07/11/13 Look over the 60K t-belt FAQ on this web site - - jzack 22:57:52 07/11/13 Thanks for the tip (n/m) - stockplayerz(nyc) 23:05:37 07/11/13 IMHO, opt for the silicone ones, never replace again. (n/m) - BigTDogg (MA) 18:22:27 07/13/13 how did u pressurize the system? (n/m) - LivinTheDream 21:23:33 07/11/13 Cooling system pressure tester - Gordo 93TT Daytona 21:36:38 07/11/13 Harbor Freight sells a kit too... - BOOZTD 3 22:50:51 07/11/13 I bought the Stant kit and then ordered the individual - Gordo 93TT Daytona 14:46:52 07/13/13 You can also use dye - BOOZTD 3 22:52:00 07/11/13 Blue LED light, no dye needed (n/m) - dogpile 23:03:15 07/12/13
Post a Followup	You cannot reply to this message because you are not logged in.