Subject	500+ cams won't affect reliability at all
Posted by	aliaZ on July 11, 2013 at 6:14 PM
	This message has been viewed 218 times.
In Reply To	Aliaz, Any suggestions on build options? posted by eriksu9 on July 10, 2013 at 10:02 AM
Message	The quality of your tune is by far the most important aspect of a reliable build...assuming, of course, that the machine work was done correctly. There are a lot of hack machinists out there. I recommend you find a way to double check the clearances before you put the engine together, no matter who does it or how good their reputation is.
Follow Ups	Wiseco pistons 87.5mm or bore to 88mm? - eriksu9 08:36:14 07/09/13 88 is fine, still leaves 2mm to play with down the road. - samsung-Z [Houston] 09:30:31 07/09/13 87.5 is still an overbore (1st size up) - ZXoltan 09:46:34 07/09/13 Cool my thoughts also.. - eriksu9 10:05:50 07/09/13 Might want to look at CP pistons, but really wont go wrong - ZXoltan 12:12:21 07/09/13 or Ross ftw. (n/m) - samsung-Z [Houston] 12:37:57 07/09/13 Sounds like you are boring either way.. - Antihero 13:23:44 07/09/13 I will know the answer to that question tonight - eriksu9 15:01:03 07/09/13 are you using a "shop" or Tony Myrie. if Tony, just - The Devils Z 22:19:24 07/09/13 Wait a minute "boring?" :_) - eriksu9 15:03:50 07/09/13 Extremely few people have cylinder wall thickness issues @88 - Antihero 15:47:08 07/09/13 Insignificant increase in displacement, plus... - ZXoltan 16:13:07 07/09/13 ehh.. not sure I agree - Antihero 16:55:20 07/09/13 Re: ehh.. not sure I agree - sky z 15:02:01 07/10/13 most people wouldn't know if they had ring seal problems - aliaZ 21:19:19 07/09/13 Aliaz, Any suggestions on build options? - eriksu9 10:02:15 07/10/13 500+ cams won't affect reliability at all - aliaZ 18:14:10 07/11/13 Ok my engine and pistons were untouched "stock" - eriksu9 09:58:07 07/10/13 Get the head work / 500 cams / BDE gears and water - The Devils Z 20:26:06 07/10/13
Post a Followup	You cannot reply to this message because you are not logged in.