Subject	This help?
Posted by	jkperformance on July 04, 2013 at 10:19 PM
	This message has been viewed 113 times.
In Reply To	Awesome, thanks. No rush ;-) (n/m) posted by ZXoltan on July 03, 2013 at 09:25 PM
Message	Both mount on a 4-foot standard cut 4x4 across the pallet. I haven't mounted them down as there's no play in the captive bolts, and I want to make sure the engine sits into them properly. right side mount was cut at 30* on my chopsaw, and the pass side at 32*.
Follow Ups	Afternoon project - engine hauler! - jkperformance 21:15:50 07/02/13 Re: Afternoon project - engine hauler! - PYROhafe 22:02:40 07/02/13 Sure beats my method of sitting it on a used tire. (n/m) - z32z 07:23:48 07/03/13 That's how I've always done it in the past, with good luck. - jkperformance 07:55:13 07/03/13 That's awesome. Nicely done. (n/m) - spicyZ 08:46:08 07/03/13 Nice, I like it. (n/m) - Schmeal (NV) 11:31:31 07/03/13 Like :-) Care to share the measurements? - ZXoltan 15:19:25 07/03/13 Don't mind in the least! I'll pull it apart tomorrow after - jkperformance 21:01:43 07/03/13 Awesome, thanks. No rush ;-) (n/m) - ZXoltan 21:25:37 07/03/13 This help? - jkperformance 22:19:01 07/04/13
Post a Followup	You cannot reply to this message because you are not logged in.