| Hi guys I been diagnosing issues with my car (come to find that my Defi display gauge was causing a feedback loop to my ECU and to my gauge cluster (sent cluster to DvDBurn) via Vehicle speed input causing my car to have random issues with stutter and etc. Someone else wired most of the electronics and wired them all into the stereo wire and I like to re do this as they should be Ignition ON power not Accessory as it is now. I have the following items to be redone 1. Innovative XD-16 display gauge (0.2A)
2. Tein EFDC controller (not sure on amperage will meter it)
3. HKS EVC-EZ (unknown amperage)
4. Innovative Wideband Controller (3A)
5. Escort SRX Radar/Jammer
6. Defi Gauge Controller (2.5A) runs gauges and display I have been looking at the Bussman and Painless stuff with and without grounding buss. What ideally would like is to run a 10gauge power wire possibly also a ground wire from the battery, install a fuse near the battery, then run it to a relay that is triggered by Ignition on. Something like this (excuse the rough drawing). 
But I like to integrate the relay and fuse block together to reduce the clutter if possible.
I also need a source for the ignition Power (any recommendations?).
|
recommendation request for aftermarket fuse block with relay - 
