Subject	Afternoon project - engine hauler!
Posted by	jkperformance on July 02, 2013 at 9:15 PM
	This message has been viewed 673 times.
Message	This coming week/weekend (sometime therein) I'm heading up to the poconos to pick up a motor from member Jayru, and wanted a solid way of holding it in the back end of my truck. I also wanted an extra bit of strapping it down to deter it from walking off while I'm watching the qualifying runs at the Pocono Indycar 400. Slapped the oil pan back on my old block (that may get turned into a coffee table) and got to work. This is what I ended up with: The pallet just barely fits between my wheel wells, and I figure this is a little better than just sitting on a tire, and strapped to the corners.
Follow Ups	Afternoon project - engine hauler! - jkperformance 21:15:50 07/02/13 Re: Afternoon project - engine hauler! - PYROhafe 22:02:40 07/02/13 Sure beats my method of sitting it on a used tire. (n/m) - z32z 07:23:48 07/03/13 That's how I've always done it in the past, with good luck. - jkperformance 07:55:13 07/03/13 That's awesome. Nicely done. (n/m) - spicyZ 08:46:08 07/03/13 Nice, I like it. (n/m) - Schmeal (NV) 11:31:31 07/03/13 Like :-) Care to share the measurements? - ZXoltan 15:19:25 07/03/13 Don't mind in the least! I'll pull it apart tomorrow after - jkperformance 21:01:43 07/03/13 Awesome, thanks. No rush ;-) (n/m) - ZXoltan 21:25:37 07/03/13 This help? - jkperformance 22:19:01 07/04/13
Post a Followup	You cannot reply to this message because you are not logged in.