Subject	That may very well be the starter itself not fully kicking
Posted by	Ashman2k2 on June 19, 2013 at 6:58 PM
	This message has been viewed 120 times.
In Reply To	That may explain my issue. posted by bstyle03 on June 19, 2013 at 11:16 AM
Message	out the pinion. But it can also be worn flywheel ring gear in combination with too much shim. Only way to find out is to inspect.
Follow Ups	Starter shim for na trans and tt flywheel wrong size - Ashman2k2 09:22:06 06/19/13 What is the correct thickness? (n/m) - Bumblebeetuna 10:40:12 06/19/13 each girl has her own opinion - Shiers69 11:17:08 06/19/13 About 2mm - Ashman2k2 18:54:19 06/19/13 That may explain my issue. - bstyle03 11:16:57 06/19/13 Ah crap, logged in on wrong name again. (n/m) - bstyleZ 11:18:56 06/19/13 The teeth on your FW are likely damaged. (n/m) - Bernie (NoVA) 11:21:09 06/19/13 I have accepted this as a possibility. - bstyleZ 13:07:29 06/19/13 if the problem was the shim then it would always grind - Bernie (NoVA) 14:50:43 06/19/13 2nd (n/m) - Greg D. (Specialty-Z) 17:32:11 06/19/13 That may very well be the starter itself not fully kicking - Ashman2k2 18:58:01 06/19/13 I went with an NA flywheel with the SouthBent NA sized - LivinTheDream 14:15:02 06/19/13 Bought mine from Zspeed for my TT conversion. Never - PiotrC70 14:43:51 06/19/13
Post a Followup	You cannot reply to this message because you are not logged in.