Subject	I have accepted this as a possibility.
Posted by	bstyleZ on June 19, 2013 at 1:07 PM
	This message has been viewed 117 times.
In Reply To	The teeth on your FW are likely damaged. (n/m) posted by Bernie (NoVA) on June 19, 2013 at 11:21 AM
Message	But is what the OP is saying true? I believe I have the RameyZ one from Z1. Is it in fact the wrong thickness? If so, is there another company that makes a correct thickness shim? I'll have to inspect my flywheel later to verify damage.
Follow Ups	Starter shim for na trans and tt flywheel wrong size - Ashman2k2 09:22:06 06/19/13 What is the correct thickness? (n/m) - Bumblebeetuna 10:40:12 06/19/13 each girl has her own opinion - Shiers69 11:17:08 06/19/13 About 2mm - Ashman2k2 18:54:19 06/19/13 That may explain my issue. - bstyle03 11:16:57 06/19/13 Ah crap, logged in on wrong name again. (n/m) - bstyleZ 11:18:56 06/19/13 The teeth on your FW are likely damaged. (n/m) - Bernie (NoVA) 11:21:09 06/19/13 I have accepted this as a possibility. - bstyleZ 13:07:29 06/19/13 if the problem was the shim then it would always grind - Bernie (NoVA) 14:50:43 06/19/13 2nd (n/m) - Greg D. (Specialty-Z) 17:32:11 06/19/13 That may very well be the starter itself not fully kicking - Ashman2k2 18:58:01 06/19/13 I went with an NA flywheel with the SouthBent NA sized - LivinTheDream 14:15:02 06/19/13 Bought mine from Zspeed for my TT conversion. Never - PiotrC70 14:43:51 06/19/13
Post a Followup	You cannot reply to this message because you are not logged in.