Subject	I can't point and laugh :(
Posted by	PCVI on June 10, 2013 at 8:35 AM
	This message has been viewed 223 times.
In Reply To	hahaha you elitsists are noob posted by fuzzymonkey on June 09, 2013 at 07:11 PM
Message	I did the same last week. Not mangled nearly to that degree, but enough to have to de-pin and reuse my old connector.
Follow Ups	hahaha you elitsists are noob - fuzzymonkey 19:11:48 06/09/13 HA (n/m) - Stanky 19:26:56 06/09/13 How on earth did you break the new one? (n/m) - Boosted1 20:06:49 06/09/13 Once this bracket is removed, installs and removals are - Krazyd27(Houston) 20:50:46 06/09/13 Can those be removed without removing the dash? (n/m) - Evan_Wright (Ca) 21:03:32 06/09/13 Yes and no. - TriniTT 21:40:05 06/09/13 pulling the evaporator box takes a new minutes but makes - Dane (Houston) 01:53:40 06/10/13 yes - aliaZ 06:09:13 06/10/13 Any tips on this? - bartz32tt 07:07:22 06/10/13 There's an upward vent stack that you remove - Jayru 08:44:12 06/10/13 Do you also remove the blower assembly? - bartz32tt 08:54:24 06/10/13 I've never had to remove the blower motor - Jayru 08:14:33 06/11/13 However you have to evacuate the AC system to do that. (n/m) - Bernie (NoVA) 08:16:05 06/10/13 Seems like a lot of extra and unnecessary work. (n/m) - TriniTT 09:35:09 06/10/13 maybe 94+ is different - LJZTT 10:32:42 06/10/13 Same here. - TriniTT 10:43:40 06/10/13 then don't do it (n/m) - aliaZ 10:34:04 06/10/13 duh (n/m) - aliaZ 10:32:37 06/10/13 Stick a rod or short prybar through the hole - ConVerTT 08:12:18 06/10/13 2nd. Use a prybar on the firewall. Once installed you tap - z32z 08:56:04 06/10/13 Correct, Convertt. That is the method I use. If you look at - Krazyd27(Houston) 11:45:32 06/10/13 !!!!!! - fuzzymonkey 12:09:51 06/10/13 You're doing it wrong. (n/m) - Bernie (NoVA) 21:57:11 06/09/13 LOL, yeah. WTF? (n/m) - ConVerTT 21:58:56 06/09/13 3rd, not sure what he could have possibly been doing to it (n/m) - LJZTT 22:57:46 06/09/13 LOL.. (n/m) - Ash's Z 11:37:44 06/10/13 I can't point and laugh :( - PCVI 08:35:58 06/10/13 Here's another way of doing it - Barry(TN) 21:04:20 06/10/13
Post a Followup	You cannot reply to this message because you are not logged in.