Subject	I just made the last payment on my seat of Rapidform XOS3 :) (n/m)
Posted by	Jim (Selin Design) on June 02, 2013 at 5:02 AM
	This message has been viewed 203 times.
In Reply To	It's not the irregularities of the model you have to worry posted by i_s_64 on June 01, 2013 at 08:49 PM
Message
Follow Ups	3D Scanning - ltullos 11:48:03 05/31/13 As far as DIY laser scanning goes.... - Schmeal (NV) 12:06:10 05/31/13 It's one of the hardest things to setup, - i_s_64 14:02:43 05/31/13 Re: 3D Scanning - ltullos 19:05:05 05/31/13 We use a FaroArm scanner at work. - DVDBURN (MD) 19:48:32 05/31/13 Hello $40k (n/m) - i_s_64 20:44:29 06/01/13 Re: 3D Scanning - ltullos 20:59:35 05/31/13 Re: 3D Scanning - ltullos 13:33:58 06/01/13 Scanning is only the first step... - Jim (Selin Design) 17:00:11 06/01/13 Re: Scanning is only the first step... - ltullos 20:22:51 06/01/13 It's not the irregularities of the model you have to worry - i_s_64 20:49:39 06/01/13 I just made the last payment on my seat of Rapidform XOS3 :) (n/m) - Jim (Selin Design) 05:02:23 06/02/13 I'll shoot you an email tomorrow (n/m) - Jim (Selin Design) 05:03:20 06/02/13
Post a Followup	You cannot reply to this message because you are not logged in.