Subject	It's one of the hardest things to setup,
Posted by	i_s_64 on May 31, 2013 at 2:02 PM
	This message has been viewed 196 times.
In Reply To	As far as DIY laser scanning goes.... posted by Schmeal (NV) on May 31, 2013 at 12:06 PM
Message	one of the hardest things to keep calibrated and among the most annoying sequence of instructions that you must perform to complete one section of a scan. Then you have to do it a bunch of other times to build the full 3D Image. Not to mention all the hardware that you have to get together just to make a proper image. With all the dicking around your time is better spend investing $10k in a ready to scan 3D scanner. Or you can go with Nextengine for $3k that I've heard nothing but bad reviews on. The advances in this technology are just going too slowly right now to make it attainable for the average computer guy.
Follow Ups	3D Scanning - ltullos 11:48:03 05/31/13 As far as DIY laser scanning goes.... - Schmeal (NV) 12:06:10 05/31/13 It's one of the hardest things to setup, - i_s_64 14:02:43 05/31/13 Re: 3D Scanning - ltullos 19:05:05 05/31/13 We use a FaroArm scanner at work. - DVDBURN (MD) 19:48:32 05/31/13 Hello $40k (n/m) - i_s_64 20:44:29 06/01/13 Re: 3D Scanning - ltullos 20:59:35 05/31/13 Re: 3D Scanning - ltullos 13:33:58 06/01/13 Scanning is only the first step... - Jim (Selin Design) 17:00:11 06/01/13 Re: Scanning is only the first step... - ltullos 20:22:51 06/01/13 It's not the irregularities of the model you have to worry - i_s_64 20:49:39 06/01/13 I just made the last payment on my seat of Rapidform XOS3 :) (n/m) - Jim (Selin Design) 05:02:23 06/02/13 I'll shoot you an email tomorrow (n/m) - Jim (Selin Design) 05:03:20 06/02/13
Post a Followup	You cannot reply to this message because you are not logged in.