Subject	It will cost more than purchasing a used
Posted by	ZXRider on May 27, 2013 at 3:39 PM
	This message has been viewed 226 times.
In Reply To	3D Printing posted by f1ym4n on May 27, 2013 at 01:52 PM
Message	Headlight that does not have a broken base. I know the issue you speak of since my driver's side head light droops cause of a crack at the bottom of the adjusting assembly. To get the base modeled correctly and printed it wil cost a few hundred dollars. We got an intake manifold printed with ABS material and it costed $500. Buy Zama Posters Here I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM
Follow Ups	3D Printing - f1ym4n 13:52:35 05/27/13 It will cost more than purchasing a used - ZXRider 15:39:53 05/27/13 yeah but if you were a vendor looking to sell a lot of a - LJZTT 23:09:22 05/27/13
Post a Followup	You cannot reply to this message because you are not logged in.