Subject	I did pretty much the same thing
Posted by	Shiers69 on May 22, 2013 at 10:32 PM
	This message has been viewed 226 times.
In Reply To	I'm currently doing ES bushings. posted by AHos(Chicago) on May 22, 2013 at 09:53 PM
Message	If you have the time to do it, you might as well clean up the welds and have it sandblasted and powdercoated while it's without bushings.
Follow Ups	New NA subframe or Whiteline subframe bushings? - ConVerTT 15:51:02 05/22/13 Everyone values their time differently - Shiers69 16:49:55 05/22/13 I'm currently doing ES bushings. - AHos(Chicago) 21:53:58 05/22/13 I did pretty much the same thing - Shiers69 22:32:34 05/22/13 Air chisel helps getting the sleeves out (n/m) - BlackholeZ 02:02:37 05/23/13 2nd, forget sawzall (n/m) - ZonaZ 14:54:38 05/23/13 So you just try and get a bit a little smaller than the - Jayru 14:38:57 05/23/13 Exactly. - AHos(Chicago) 19:55:25 05/23/13 ALL sleeves out for whitelines, leave a sleeve for ES (n/m) - Antihero 21:43:58 05/23/13 Are you running whitelines? Any feedback? (n/m) - ConVerTT 21:52:37 05/23/13 still sitting on the shelf. (n/m) - Antihero 23:16:47 05/23/13 i have a new subframe sitting in my garage right now. - slayer fan 02:06:27 05/23/13 New Subframe (n/m) - Madhatter10-6 07:08:43 05/23/13 Joe from ZSpeed had a set of the Whitelines @ ZdayZ - - Bernie (NoVA) 00:22:38 05/24/13 Re: Joe from ZSpeed had a set of the Whitelines @ ZdayZ - - Joe@ZSpeedperformance 16:06:32 05/24/13 Hey Awesome Joe! - ConVerTT 19:01:11 05/24/13 I chose to go Whiteline & i have not installed them yet. (n/m) - SuparexTT 22:08:47 05/24/13
Post a Followup	You cannot reply to this message because you are not logged in.