Subject	Storing the VG30DETT.
Posted by	Tanley on May 20, 2013 at 6:18 PM
	This message has been viewed 193 times.
Message	Just wondering what everybody recommends for storing the engine for an extended period of time. Read a few posts about using fogging oil or putting some motor oil down each cylinder and turning it over a few times every so often. Fuel stabilizer was also recommended to be run through the fuel system before storage. Any other recommendations?
Follow Ups	Storing the VG30DETT. - Tanley 18:18:07 05/20/13 I recommend a hermetically sealed container. - MixManMash 18:28:33 05/20/13 Make sure to purge with dry nitrogen (n/m) - black300zx 19:51:42 05/20/13 Fuel stabilizer, and check all rubber seals and rubber lines - Milo (Nismo Fiesta) 18:44:33 05/20/13 On and jack up the tires off the ground or invest in a bowed - Milo (Nismo Fiesta) 18:46:39 05/20/13 I read it is not good to jack up the car and leave the tires - evan_aggie 20:05:20 05/20/13 Why is that? (n/m) - ZXoltan 20:39:41 05/20/13 Causes the suspension to sag, from what I've heard. (n/m) - AHos(Chicago) 21:14:49 05/20/13 Yes, it can if left for long periods of time and depending - Milo (Nismo Fiesta) 21:30:39 05/20/13 Same. I was always told if you are storing a car, take - MixManMash 20:41:39 05/20/13 Engine in the car or out of the car? Long block, - John (MD) 18:44:50 05/20/13 Data data data....... - Tanley 18:53:55 05/20/13 Cover the openings in the car and on the engine to avoid - MixManMash 20:44:31 05/20/13 dust, debris, moisture... rodents. (n/m) - BlackholeZ 23:06:53 05/20/13 Why? - Antihero 09:19:28 05/21/13 There will be an oily film on everything anyways. Keeping - MixManMash 18:38:05 05/21/13
Post a Followup	You cannot reply to this message because you are not logged in.