Subject	Question: How to properly adjust throttle cable and linkages
Posted by	Terayonneo on May 18, 2013 at 10:47 PM
	This message has been viewed 626 times.
Message	I was wondering what the proper way to adjust the throttle bodies for 'full throttle' opening? I know there is an adjusting screw right beside where the throttle cable gets put in the middle linkage, but I don't know where u should set it... This is a picture of the side of the throttle body without the TPS and is with the throttle 'all the way open'... Now my question is should the 'stop' on the shaft be as close as possible to the stop on the throttle bodies or does this right? Sorry for the poor quality IPhone pics... If anyone has any advice that would be great, thank you.
Follow Ups	Question: How to properly adjust throttle cable and linkages - Terayonneo 22:47:30 05/18/13 The butterflies should be perpendicular to the flow of air - KongZTT GT28RS MD 06:55:32 05/19/13 parallel! I meant! - KongZTT GT28RS MD 09:41:05 05/19/13 Thanks for the tips, so as long as they are parallel to the - Terayonneo 16:49:38 05/19/13 Keep in mind that the TB's are at a downward angle - BoneZ (MD) 11:55:02 05/19/13 Thats why I said parralell to the air flow. (n/m) - KongZTT GT28RS MD 19:57:04 05/19/13 yessir - that was for the general audience. (n/m) - BoneZ (MD) 20:31:22 05/19/13 :) (n/m) - KongZTT GT28RS MD 21:24:43 05/19/13
Post a Followup	You cannot reply to this message because you are not logged in.