Subject	Yep.. me too (n/m)
Posted by	KongZTT GT28RS MD on May 12, 2013 at 1:10 PM
	This message has been viewed 145 times.
In Reply To	I always use the holes where the boost solenoids bolt posted by BOOZTD 3 on May 12, 2013 at 01:08 PM
Message
Follow Ups	bolts to pull motor?? - PYROhafe 11:04:51 05/12/13 I use a strap and pull the engine & trans together. (n/m) - TTZ2NV(EPTmotorsports) 11:19:28 05/12/13 How do you like that method compared to separating them? - Madhatter10-6 11:52:19 05/12/13 I would also like to know - Stanky 13:06:11 05/12/13 Did it together once. never again. - Antihero 13:51:41 05/12/13 There are two ways of looking at this. - DVDBURN (MD) 14:35:53 05/12/13 Can you please explain what part is a PITA? - Antihero 08:38:52 05/13/13 the plenum bolts center bolts work on the sides.. M8x1.25 - KongZTT GT28RS MD 12:34:00 05/12/13 I always use the holes where the boost solenoids bolt - BOOZTD 3 13:08:27 05/12/13 Yep.. me too (n/m) - KongZTT GT28RS MD 13:10:57 05/12/13 Fwiw that's not a very strong point especially if the side - Bernie (NoVA) 13:31:27 05/12/13 I'm sure there are better options, its just my go-to - BOOZTD 3 14:29:51 05/12/13 Re: bolts to pull motor?? - PYROhafe 14:10:59 05/13/13
Post a Followup	You cannot reply to this message because you are not logged in.