Subject	Getting ready to do this myself, thanks for the tutorial!
Posted by	BlackholeZ on May 05, 2013 at 5:41 PM
	This message has been viewed 233 times.
In Reply To	HOW TO: Remove freeze plugs and port coolant gallies posted by KongZTT GT28RS MD on May 04, 2013 at 10:10 PM
Message	The local guru uses a ~3/4" punch that is tapered to one side, does the same punch method as you, but then spins it and uses it like a prybar under the lip of the freeze plug to pop it out. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	HOW TO: Remove freeze plugs and port coolant gallies - KongZTT GT28RS MD 22:10:00 05/04/13 I dont recommend this to someone who isn't hot tanking - KongZTT GT28RS MD 22:18:09 05/04/13 For the home gamers... - ConVerTT 08:35:01 05/05/13 That is a great idea! Thank you! (n/m) - KongZTT GT28RS MD 08:45:07 05/05/13 No problem. Glad you liked it! (n/m) - ConVerTT 12:24:05 05/05/13 For the freeze plugs - BOOZTD 3 03:20:56 05/05/13 ahh.. I do have some of that in the shop.. thanks! (n/m) - KongZTT GT28RS MD 08:45:34 05/05/13 Great job!! Did you replace the freeze plugs with brass? (n/m) - fst300zx 06:38:58 05/05/13 Re: Great job!! Did you replace the freeze plugs with brass? - wild_maxx 08:04:55 05/05/13 I will be using OEM ones.. can't go wrong with OEM.. - KongZTT GT28RS MD 08:46:09 05/05/13 FWIW, I use a piece of rebar and a sledge hammer - aliaZ 09:03:45 05/05/13 ahh.. good idea! - KongZTT GT28RS MD 09:39:07 05/05/13 Does IPP take care of all of this on thier rebuilds? (n/m) - RonZ300 (Socal) 10:33:15 05/05/13 they are supposed to.. - KongZTT GT28RS MD 12:46:57 05/05/13 Some pics of the rear and top.. - KongZTT GT28RS MD 11:02:43 05/05/13 aawww man, I needed this a month ago... (n/m) - JAMMZ 11:32:50 05/05/13 Getting ready to do this myself, thanks for the tutorial! - BlackholeZ 17:41:17 05/05/13 I need a set of vtc caps! (n/m) - KongZTT GT28RS MD 17:54:16 05/05/13 I'm on hold because of urethane - BlackholeZ 19:57:24 05/05/13 sounds good! - KongZTT GT28RS MD 20:22:17 05/05/13
Post a Followup	You cannot reply to this message because you are not logged in.