Subject	It has to do with the quality of the casting
Posted by	BlackholeZ on May 05, 2013 at 5:33 PM
	This message has been viewed 209 times.
In Reply To	is it known for certain that coatings will lead to metal posted by evan_aggie on May 05, 2013 at 08:52 AM
Message	Crap castings will crack no matter what. The MS castings and Turbine housings are quality. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Ceramic coated my MS manifolds and turbine housings.. - KongZTT GT28RS MD 23:11:58 05/04/13 snap! - JaffaUK 04:14:38 05/05/13 is it known for certain that coatings will lead to metal - evan_aggie 08:52:04 05/05/13 It has been said that.. - KongZTT GT28RS MD 09:41:26 05/05/13 It has to do with the quality of the casting - BlackholeZ 17:33:15 05/05/13 Nice man! (n/m) - KongZTT GT28RS MD 09:39:35 05/05/13 ok so where can you buy ceramic coating to do this yourself? - fst300zx 06:34:20 05/05/13 This^ and I have heard ceramic coatings are "rust prone" (n/m) - VERTTZ 07:40:34 05/05/13 I have heard that some are not a moisture barrier.. - KongZTT GT28RS MD 08:50:00 05/05/13 Supposedly this is good up to 2000*F - KongZTT GT28RS MD 08:48:41 05/05/13 the coatings from HPC I got on my MS manis back in 08 - LJZTT 09:07:56 05/05/13 Degrees symbol (°) hold alt and type 0176 on the numpad :-) (n/m) - BlackholeZ 17:35:53 05/05/13 thanks :) (n/m) - KongZTT GT28RS MD 19:49:32 05/05/13 What was the highest temp you had to bake the parts at? (n/m) - 280ZuL8R 09:33:05 05/05/13 I believe it was supposed to bake at 700*.. - KongZTT GT28RS MD 09:37:45 05/05/13 Re: Ceramic coated my MS manifolds and turbine housings.. - z32f4i 14:25:13 05/06/13 Re: Re: Ceramic coated my MS manifolds and turbine housings.. - CCPcoatings 18:45:09 05/07/13 Re: Re: Ceramic coated my MS manifolds and turbine housings.. - CCPcoatings 18:59:54 05/07/13
Post a Followup	You cannot reply to this message because you are not logged in.