Subject	^^This!!...is not the first time I've seen this happen
Posted by	RobZ32 on May 05, 2013 at 4:32 PM
	This message has been viewed 244 times.
In Reply To	I think your IC's might be pushing the bumper out. posted by Evan(CA) on May 04, 2013 at 03:10 PM
Message	I believe the solution is bend the brackets until the IC does not touch the lower part of the bumper. Rob It's never "DONE", just finished enough to drive :-) - BigTDogg (MA)
Follow Ups	ahhh looky what came in and i installed - traydogg6969(Pittsburgh) 14:16:03 05/04/13 Very nice :) (n/m) - ZpwrLab 14:18:43 05/04/13 old looks straight with the fender. (n/m) - z_samurai 14:37:31 05/04/13 Why does the bumper bulge out at the bottom? (n/m) - David G 14:43:33 05/04/13 Re: Why does the bumper bulge out at the bottom? - traydogg6969(Pittsburgh) 14:46:59 05/04/13 I think your IC's might be pushing the bumper out. - Evan(CA) 15:10:41 05/04/13 2nd^ looks funny. something is pushing the bottom corners - nonstopna 00:22:09 05/05/13 my Zspeed front splashshield pushes down on the outer - LJZTT 04:43:52 05/05/13 ^^This!!...is not the first time I've seen this happen - RobZ32 16:32:55 05/05/13 Looks like your splash shields aren't installed. (n/m) - TriniTT 16:29:52 05/04/13 i do need a splash shield. - traydogg6969(Pittsburgh) 10:56:49 05/05/13 Nice! Now get that front end a little lower ;) (n/m) - Devin300zx 15:06:09 05/04/13 I think you car looks great. Nice upgrade from the old look (n/m) - David G 15:17:45 05/04/13 What are you doing with the Gracer? I personally - PiotrC70 15:18:30 05/04/13 GRacer might look good on a VerTT.... (n/m) - ConVerTT 08:38:51 05/05/13 Yeah, I thought so too. JSpec looks great, we all know that - PiotrC70 09:27:49 05/05/13 Nice! (n/m) - TriniTT 16:29:10 05/04/13 significant improvement (n/m) - Adam (NoVA) 16:34:48 05/04/13 Looks good! I plan to put a mesh grille when I get mine - Lumpydonut 19:44:05 05/04/13 Damn, did you dip your Z in sugar? - Mike TDK (NoVA) 06:35:10 05/05/13 Very nice....big improvement - RobZ32 16:33:57 05/05/13
Post a Followup	You cannot reply to this message because you are not logged in.