Subject	That shift support bracket could do with some weight
Posted by	MikeC(NZ) on April 30, 2013 at 3:29 AM
	This message has been viewed 189 times.
In Reply To	Will do. Thanks for the advice, buddy. (n/m) posted by Milo (Nismo Fiesta) on April 30, 2013 at 12:52 AM
Message	reduction - few speed holes :)
Follow Ups	Some updates on Project Lowfatz - Milo (Nismo Fiesta) 23:10:50 04/29/13 Looking good! Keep it up! (n/m) - TheTwinZ (Peru) 23:20:46 04/29/13 be sure to check caliper clearance in the rear - aliaZ 23:59:09 04/29/13 Will do. Thanks for the advice, buddy. (n/m) - Milo (Nismo Fiesta) 00:52:59 04/30/13 That shift support bracket could do with some weight - MikeC(NZ) 03:29:10 04/30/13 Thought about that as well. Might run it through the drill - Milo (Nismo Fiesta) 09:28:05 04/30/13 An ebay shifter? Come on :) (n/m) - Woody75 (Denver) 10:49:22 04/30/13 Had it lying around. Want to make me one? :) (n/m) - Milo (Nismo Fiesta) 14:10:23 04/30/13 I have a batch sitting here. (n/m) - Woody75 (Denver) 23:36:10 04/30/13 Curious about the fender clearance with your front and rears - Jonezy 10:53:46 04/30/13 Have a roller, either way it is going to fit in there. Worse - Milo (Nismo Fiesta) 14:12:43 04/30/13 Sounds cool, can't wait to see. (n/m) - Jonezy 15:24:30 04/30/13 good stuff....keep up the good work (n/m) - RobZ32 10:59:16 04/30/13 Awesome to see you're still working over that NA motor - black300zx 16:21:43 04/30/13 Do you have a weight number on the project - Glooj 15:04:09 05/01/13
Post a Followup	You cannot reply to this message because you are not logged in.