Subject	Re: No I haven't installed that engine yet.
Posted by	qcsolo on April 27, 2013 at 10:54 PM
	This message has been viewed 224 times.
In Reply To	No I haven't installed that engine yet. posted by SIM300 on April 27, 2013 at 10:08 PM
Message	I have built my own disco potatoe turbo set for about $1000.00 total on OEM Garrett bushing cartridge using Chinese shaft (0.86 AR 76 Trim 53.9 mm dia) and 5 bolts exhaust manifold. I have changed the compressor turbine (0.60 AR, 62 Trim exd.60 mm and ind 46.5 mm) for similar set-up GT2860R which I have made an OEM compressor housing machined to fit this impeller shape. Finally, installed ajustable wastegate actuators which open at 10 psi boost Work great no much lag and they can be rebuid with oversize Garrett kits ! Released 457 RWHP and 397 torque at 17 psi on 94 octane gas...so guess around 475 RWHP at 18 psi max
Follow Ups	Any pictures of CZP garrett GT2860R(Disco potato kit) ? - Z-speed 13:13:30 04/27/13 Re: Any pictures of CZP garrett GT2860R(Disco potato kit) ? - SIM300 16:58:09 04/27/13 Strange that they use a smaller housing. - Z-speed 19:27:11 04/27/13 No I haven't installed that engine yet. - SIM300 22:08:14 04/27/13 Re: No I haven't installed that engine yet. - qcsolo 22:54:00 04/27/13 Good luck with longevity. - The Hawk 00:42:16 04/28/13 Re: Good luck with longevity. - qcsolo 10:16:42 04/28/13 Re: Re: Good luck with longevity. - ZBOOSTT 15:17:09 04/28/13 Re: Re: Re: Good luck with longevity. - ZBOOSTT 15:20:20 04/28/13 You think the 530's spool faster? - ZXoltan 18:21:40 04/28/13 Re: You think the 530's spool faster? - ZBOOSTT 19:25:19 04/28/13 Re: Strange that they use a smaller housing. - BLACKBEAST 03:38:05 04/28/13 If I had my time over again I would go with Z1 kit. - SIM300 19:54:37 04/28/13
Post a Followup	You cannot reply to this message because you are not logged in.