Subject	I used to run this setup on my old RPF1's and had no problem
Posted by	*BK300ZX* on April 24, 2013 at 8:50 AM
	This message has been viewed 226 times.
In Reply To	Trouble fitting my New RPF1'S!!!! Try and Figure this Out! posted by aarondc805 on April 24, 2013 at 12:06 AM
Message	I had 17x8 +35 and 17x9 +35 with 245/45/17 and 275/40/17 respectively. The front tire is pretty large and will definitely fill the front wheel well. You may have too much front caster which places the wheel closer to the bumper. All you should have to do is draw is back a little bit with a proper alignment. Your description is a little vague, but i will assume you are running 17x8.5 +35 and 17x9 +35 with the same tire setup as what i just listed. If that is correct, you should have no problems once you adjust the front caster. Hopefully this helps.
Follow Ups	Trouble fitting my New RPF1'S!!!! Try and Figure this Out! - aarondc805 00:06:35 04/24/13 Re: Trouble fitting my New RPF1'S!!!! Try and Figure this Out! - aarondc805 00:08:21 04/24/13 Re: Trouble fitting my New RPF1'S!!!! Try and Figure this Out! - Buckaroo Banzai 00:11:20 04/24/13 If he is running powertrix FUCA's he shouldn't have rubber - intel 00:26:41 04/24/13 Re: If he is running powertrix FUCA's he shouldn't have rubber - Buckaroo Banzai 01:58:37 04/24/13 shouldn't =/= doesn't (n/m) - MixManMash 07:23:37 04/24/13 Re:ALL - aarondc805 19:12:16 04/24/13 Are the wheels 8.5" or 9.5" wide? - ZXRider 01:22:18 04/24/13 Sidwall too large up front imo - gnozahs 01:55:49 04/24/13 Sidewall is 110.25mm. The 275/40 is 110mm. - MixManMash 02:42:10 04/24/13 Check your tension rods (n/m) - Z32TT-R 08:29:06 04/24/13 I used to run this setup on my old RPF1's and had no problem - *BK300ZX* 08:50:07 04/24/13 +35 is not the same fitment on 8.5 as it is on a 8.... - LJZTT 12:06:49 04/24/13 True, but I am running 17x9 +35 with 275/40/17 without - MixManMash 14:10:46 04/24/13 same fascia? same ride height? - LJZTT 09:03:39 04/25/13 Yeah, Im currently running 18x9.5+38 with a 10mm spacer up - *BK300ZX* 17:55:23 04/24/13 Agreed. The lack of caliper clearance on the RPF1s make it - MixManMash 19:38:36 04/24/13 Head to an alignment shop, that doesn't add up. (n/m) - TriniTT 17:37:57 04/24/13
Post a Followup	You cannot reply to this message because you are not logged in.