Subject	In that case you're def better off w the smaller one
Posted by	ZXoltan on April 15, 2013 at 7:04 AM
	This message has been viewed 223 times.
In Reply To	they flow about the same posted by aliaZ on April 15, 2013 at 12:09 AM
Message	Plus, Supertechs are a tad cheaper ;-) The valves are already very tight within the head
Follow Ups	Supertech 0.5mm vs Ferrea 1mm oversize valves? - KongZTT GT28RS MD 07:02:29 04/14/13 not much to be gained from that 1 isolated valve mod. - samsung-Z [Houston] 08:17:11 04/14/13 getting a full valve job anyway.. Which is why I am asking.. - KongZTT GT28RS MD 08:51:17 04/14/13 Also need to purchas new oem intake valves at a minimum. - KongZTT GT28RS MD 12:27:30 04/14/13 why do they say the valves are soft? where they are actually - toykoz32 15:45:01 04/14/13 haha.. I guess because they look soft when they are worn (n/m) - KongZTT GT28RS MD 18:38:10 04/14/13 Also need to purchas new oem intake valves at a minimum. - KongZTT GT28RS MD 13:12:17 04/14/13 Come on .. nobody else? (n/m) - KongZTT GT28RS MD 20:13:38 04/14/13 I remember greg saying something about the shrouding effect. - michaell32 (FL) 20:27:10 04/14/13 they flow about the same - aliaZ 00:09:37 04/15/13 In that case you're def better off w the smaller one - ZXoltan 07:04:46 04/15/13 Mike Smith recommended the .5 over the 1mm. - Woody75 (Denver) 10:51:28 04/15/13 Re: Supertech 0.5mm vs Ferrea 1mm oversize valves? - BLACKBEAST 00:51:56 04/16/13 I am running 88mm pistons. Stock compression - KongZTT GT28RS MD 08:50:26 04/16/13
Post a Followup	You cannot reply to this message because you are not logged in.