Subject	haha.. I guess because they look soft when they are worn (n/m)
Posted by	KongZTT GT28RS MD on April 14, 2013 at 6:38 PM
	This message has been viewed 270 times.
In Reply To	why do they say the valves are soft? where they are actually posted by toykoz32 on April 14, 2013 at 03:45 PM
Message
Follow Ups	Supertech 0.5mm vs Ferrea 1mm oversize valves? - KongZTT GT28RS MD 07:02:29 04/14/13 not much to be gained from that 1 isolated valve mod. - samsung-Z [Houston] 08:17:11 04/14/13 getting a full valve job anyway.. Which is why I am asking.. - KongZTT GT28RS MD 08:51:17 04/14/13 Also need to purchas new oem intake valves at a minimum. - KongZTT GT28RS MD 12:27:30 04/14/13 why do they say the valves are soft? where they are actually - toykoz32 15:45:01 04/14/13 haha.. I guess because they look soft when they are worn (n/m) - KongZTT GT28RS MD 18:38:10 04/14/13 Also need to purchas new oem intake valves at a minimum. - KongZTT GT28RS MD 13:12:17 04/14/13 Come on .. nobody else? (n/m) - KongZTT GT28RS MD 20:13:38 04/14/13 I remember greg saying something about the shrouding effect. - michaell32 (FL) 20:27:10 04/14/13 they flow about the same - aliaZ 00:09:37 04/15/13 In that case you're def better off w the smaller one - ZXoltan 07:04:46 04/15/13 Mike Smith recommended the .5 over the 1mm. - Woody75 (Denver) 10:51:28 04/15/13 Re: Supertech 0.5mm vs Ferrea 1mm oversize valves? - BLACKBEAST 00:51:56 04/16/13 I am running 88mm pistons. Stock compression - KongZTT GT28RS MD 08:50:26 04/16/13
Post a Followup	You cannot reply to this message because you are not logged in.