After further investigation (and realizing the were no holes for her to breath) it was my Black Friday order from Z1.
Pspec fascia, splitter, ducts, noses panel, side skirts , rear spoiler, rear hatch struts, floormats and some auth Jspec tails I picked up a month ago .
the ash massive ducts are not going to work
and the pspec fascia ducts were made to fit the psec fascia but an oem size intercooler ( there my be a market for some ducts that fit larger ic's ) . 
I have measured and lined up both ducts to the massives and tonight they will become one with a little help from the die grinder . I will post the pics of that later.
I also built these poor man ramps which work really well in clearing the front bumper and added an extra 1.5" to the lift .
the 2x4 extra boards were cut to fit between the ramps to help in aligning the ramps then put in front of the ramps and against the lip in my garage to keep the ramps from sliding .
Once the car is up just remove the 2x4's and go to work .
the fun begins now but so far the Psec fasia is a nice fit .
One Quick question : does the main front bumper support ( that holds the fog lights ) have a piece of OEM foam or foam tape that mounts to the front of it ? Mine has some worn out tape on it and im not the first one to be in there so im not sure . Thanx
|
Did my "Mail order Bride" show up a week early ? - 
