Subject	Perhaps blast is the wrong word, loosen with gun
Posted by	ttsmokin on April 10, 2013 at 10:53 AM
	This message has been viewed 173 times.
In Reply To	Only problem with your procedure is.... posted by ZXoltan on April 10, 2013 at 06:49 AM
Message	You can also mark the actual socket too, so you can see the rotations from the outside. You should be able to control the gun with quick blasts so it just loosens and does not spin it off. Alternatively a breaker bar works too. Just chock up the rear tires and ebrake on.
Follow Ups	Anyone replace th diff seal on the driveshaft side? - Red Hawk (CO) 19:12:25 04/09/13 Mine is leaking and need to replace it also. Dropping - Prof.DrunkClutch 19:30:35 04/09/13 Re: Mine is leaking and need to replace it also. Dropping - Prof.DrunkClutch 19:32:50 04/09/13 yeah thats where I looked. - Red Hawk (CO) 21:06:07 04/09/13 No need to drop subframe - ttsmokin 21:45:47 04/09/13 My diff bushings are shot so im putting in - Prof.DrunkClutch 00:12:57 04/10/13 Iirc using the impact to reinstall the nut can damage the - Z32TT-R 00:29:36 04/10/13 If you are an idiot yes, very easily - ttsmokin 00:53:09 04/10/13 Only problem with your procedure is.... - ZXoltan 06:49:34 04/10/13 Perhaps blast is the wrong word, loosen with gun - ttsmokin 10:53:15 04/10/13
Post a Followup	You cannot reply to this message because you are not logged in.