Subject	I was talking about the front crossmember
Posted by	WhiTTe Z on April 09, 2013 at 9:33 PM
	This message has been viewed 166 times.
In Reply To	the hf al jack will reach my rails without 2x4s-stock susp. (n/m) posted by BoneZ (MD) on April 09, 2013 at 04:30 PM
Message	I wouldn't be jacking it from the rails if possible.... just get a board to drive up on (Or in my case a board and an old text book) "Stance: cuz goin fast cost money yo (n/m) - ZiNnYc 08/09/12 18:23:42"
Follow Ups	Sweet deal on low profile, long-reach jack at HF - ZXoltan 18:03:03 04/08/13 2nd. paid $150 for this a few months ago. - WhiTTe Z 18:24:30 04/08/13 Bought the same one also. Good jack but still not long - z32z 21:13:34 04/08/13 the hf al jack will reach my rails without 2x4s-stock susp. (n/m) - BoneZ (MD) 16:30:29 04/09/13 I was talking about the front crossmember - WhiTTe Z 21:33:11 04/09/13 Sweeter than Yoohoo! (n/m) - ForceFedTT (SoCal) 22:04:55 04/08/13 Is that aluminum or steel? I'm guessing steel for the $. (n/m) - evan_aggie 22:06:04 04/08/13 Its steel. The Al ones dont go as high - ZXoltan 22:19:28 04/08/13 Why would you jack from the frame rail rather than the front - Inzane 11:11:41 04/09/13 cant reach the front without getting the car on ramps - BoneZ (MD) 16:28:58 04/09/13 I prefer to jack from my pinch welds using this: - aliaZ 06:29:05 04/10/13 cheaper to use a hockey puck, you just need to cut - slayer fan 10:18:35 04/10/13 Thanks for the link... just bought one (n/m) - Bucky Z 11:33:27 04/10/13
Post a Followup	You cannot reply to this message because you are not logged in.