Subject	cant reach the front without getting the car on ramps
Posted by	BoneZ (MD) on April 09, 2013 at 4:28 PM
	This message has been viewed 194 times.
In Reply To	Why would you jack from the frame rail rather than the front posted by Inzane on April 09, 2013 at 11:11 AM
Message	Or blocks Easier to pick it up from the rail, block it, then jack at the front. -___________________________________________________________-
Follow Ups	Sweet deal on low profile, long-reach jack at HF - ZXoltan 18:03:03 04/08/13 2nd. paid $150 for this a few months ago. - WhiTTe Z 18:24:30 04/08/13 Bought the same one also. Good jack but still not long - z32z 21:13:34 04/08/13 the hf al jack will reach my rails without 2x4s-stock susp. (n/m) - BoneZ (MD) 16:30:29 04/09/13 I was talking about the front crossmember - WhiTTe Z 21:33:11 04/09/13 Sweeter than Yoohoo! (n/m) - ForceFedTT (SoCal) 22:04:55 04/08/13 Is that aluminum or steel? I'm guessing steel for the $. (n/m) - evan_aggie 22:06:04 04/08/13 Its steel. The Al ones dont go as high - ZXoltan 22:19:28 04/08/13 Why would you jack from the frame rail rather than the front - Inzane 11:11:41 04/09/13 cant reach the front without getting the car on ramps - BoneZ (MD) 16:28:58 04/09/13 I prefer to jack from my pinch welds using this: - aliaZ 06:29:05 04/10/13 cheaper to use a hockey puck, you just need to cut - slayer fan 10:18:35 04/10/13 Thanks for the link... just bought one (n/m) - Bucky Z 11:33:27 04/10/13
Post a Followup	You cannot reply to this message because you are not logged in.