TwinTurbo.NET: Nissan 300ZX forum - Bought the same one also. Good jack but still not long
Subject
Bought the same one also. Good jack but still not long
Posted by
z32z
on April 08, 2013 at 9:13 PM
This message has been viewed
177
times.
In Reply To
2nd. paid $150 for this a few months ago.
posted by WhiTTe Z
on April 08, 2013 at 06:24 PM
Message
enough to reach my side rail. I still have to drive up on a 2x4.
Follow Ups
Sweet deal on low profile, long-reach jack at HF
-
ZXoltan
18:03:03 04/08/13
2nd. paid $150 for this a few months ago.
-
WhiTTe Z
18:24:30 04/08/13
Bought the same one also. Good jack but still not long -
z32z
21:13:34 04/08/13
the hf al jack will reach my rails without 2x4s-stock susp. (n/m)
-
BoneZ (MD)
16:30:29 04/09/13
I was talking about the front crossmember
-
WhiTTe Z
21:33:11 04/09/13
Sweeter than Yoohoo! (n/m)
-
ForceFedTT (SoCal)
22:04:55 04/08/13
Is that aluminum or steel? I'm guessing steel for the $. (n/m)
-
evan_aggie
22:06:04 04/08/13
Its steel. The Al ones dont go as high
-
ZXoltan
22:19:28 04/08/13
Why would you jack from the frame rail rather than the front
-
Inzane
11:11:41 04/09/13
cant reach the front without getting the car on ramps
-
BoneZ (MD)
16:28:58 04/09/13
I prefer to jack from my pinch welds using this:
-
aliaZ
06:29:05 04/10/13
cheaper to use a hockey puck, you just need to cut
-
slayer fan
10:18:35 04/10/13
Thanks for the link... just bought one (n/m)
-
Bucky Z
11:33:27 04/10/13
Post a
Followup
You cannot reply to this message because you are not
logged in
.