Subject	That was 35 sq ft??
Posted by	AHos(Chicago) on April 08, 2013 at 8:04 PM
	This message has been viewed 339 times.
In Reply To	Yes. I did a write-up (with photos) for my club newsletter posted by cherry on April 08, 2013 at 10:25 AM
Message	I think I severely under estimated how much area is back there. The MLV doesn't need to be form fitted to the curves (mainly the spare tire spot), does it? Nice write up and thank you!
Follow Ups	Anyone have experience with mass loaded vinyl? - AHos(Chicago) 12:33:46 04/07/13 I did the entire back of my Z, double layer with aircraft - RonZ300 (Socal) 13:16:56 04/07/13 Where did you buy the material? - Evan(CA) 13:25:04 04/07/13 Re: I did the entire back of my Z, double layer with aircraft - AHos(Chicago) 15:05:57 04/07/13 Also, - AHos(Chicago) 15:39:56 04/07/13 All info is here: - RonZ300 (Socal) 21:25:28 04/07/13 How many sqft did you use? (n/m) - Evan(CA) 22:02:19 04/07/13 Sorry, i dont remember... I think i got 2 rolls and had - RonZ300 (Socal) 01:59:29 04/08/13 Not really :) - Evan(CA) 03:46:33 04/08/13 I found this: - AHos(Chicago) 08:02:26 04/08/13 That all sounds great and yes, my estimates may be off as i - RonZ300 (Socal) 15:42:31 04/08/13 Good to know! - AHos(Chicago) 20:01:13 04/08/13 The MLV was thin, similar to dynamat, which is why i doubled - RonZ300 (Socal) 10:01:42 04/08/13 Did you do the floor as well? (n/m) - BigTDogg (MA) 09:18:34 04/08/13 You could look into RAAMMat Bxt II and a layer of ensolite - Drk93TT 19:49:21 04/07/13 Re: You could look into RAAMMat Bxt II and a layer of ensolite - AHos(Chicago) 21:30:32 04/07/13 Zeronoise.com has free shipping right now on Cascade - BigTDogg (MA) 20:56:26 04/07/13 B-Quiet.com is worth looking at (n/m) - scoops 22:52:44 04/07/13 Yes. I did a write-up (with photos) for my club newsletter - cherry 10:25:16 04/08/13 Nice work! (n/m) - BigTDogg (MA) 12:51:34 04/08/13 That was 35 sq ft?? - AHos(Chicago) 20:04:12 04/08/13 The photos don't show where all of the RAAMmat is installed. - cherry 08:56:57 04/09/13
Post a Followup	You cannot reply to this message because you are not logged in.