TwinTurbo.NET: Nissan 300ZX forum - Good to know!
Subject
Good to know!
Posted by
AHos(Chicago)
on April 08, 2013 at 8:01 PM
This message has been viewed
350
times.
In Reply To
That all sounds great and yes, my estimates may be off as i
posted by RonZ300 (Socal)
on April 08, 2013 at 03:42 PM
Message
This will be a summer project for me, so I will email you if I have any questions when I get around to it.
Thanks for your help!
Follow Ups
Anyone have experience with mass loaded vinyl?
-
AHos(Chicago)
12:33:46 04/07/13
I did the entire back of my Z, double layer with aircraft
-
RonZ300 (Socal)
13:16:56 04/07/13
Where did you buy the material?
-
Evan(CA)
13:25:04 04/07/13
Re: I did the entire back of my Z, double layer with aircraft
-
AHos(Chicago)
15:05:57 04/07/13
Also,
-
AHos(Chicago)
15:39:56 04/07/13
All info is here:
-
RonZ300 (Socal)
21:25:28 04/07/13
How many sqft did you use? (n/m)
-
Evan(CA)
22:02:19 04/07/13
Sorry, i dont remember... I think i got 2 rolls and had
-
RonZ300 (Socal)
01:59:29 04/08/13
Not really :)
-
Evan(CA)
03:46:33 04/08/13
I found this:
-
AHos(Chicago)
08:02:26 04/08/13
That all sounds great and yes, my estimates may be off as i
-
RonZ300 (Socal)
15:42:31 04/08/13
Good to know! -
AHos(Chicago)
20:01:13 04/08/13
The MLV was thin, similar to dynamat, which is why i doubled
-
RonZ300 (Socal)
10:01:42 04/08/13
Did you do the floor as well? (n/m)
-
BigTDogg (MA)
09:18:34 04/08/13
You could look into RAAMMat Bxt II and a layer of ensolite
-
Drk93TT
19:49:21 04/07/13
Re: You could look into RAAMMat Bxt II and a layer of ensolite
-
AHos(Chicago)
21:30:32 04/07/13
Zeronoise.com has free shipping right now on Cascade
-
BigTDogg (MA)
20:56:26 04/07/13
B-Quiet.com is worth looking at (n/m)
-
scoops
22:52:44 04/07/13
Yes. I did a write-up (with photos) for my club newsletter
-
cherry
10:25:16 04/08/13
Nice work! (n/m)
-
BigTDogg (MA)
12:51:34 04/08/13
That was 35 sq ft??
-
AHos(Chicago)
20:04:12 04/08/13
The photos don't show where all of the RAAMmat is installed.
-
cherry
08:56:57 04/09/13
Post a
Followup
You cannot reply to this message because you are not
logged in
.