Subject	The MLV was thin, similar to dynamat, which is why i doubled
Posted by	RonZ300 (Socal) on April 08, 2013 at 10:01 AM
	This message has been viewed 428 times.
In Reply To	Not really :) posted by Evan(CA) on April 08, 2013 at 03:46 AM
Message	it up almost everywhere. I used 1/2" foam in most places on top of the dynamat so that it would fit under interior panels. I used the real thick stuff under the trunk carpet.
Follow Ups	Anyone have experience with mass loaded vinyl? - AHos(Chicago) 12:33:46 04/07/13 I did the entire back of my Z, double layer with aircraft - RonZ300 (Socal) 13:16:56 04/07/13 Where did you buy the material? - Evan(CA) 13:25:04 04/07/13 Re: I did the entire back of my Z, double layer with aircraft - AHos(Chicago) 15:05:57 04/07/13 Also, - AHos(Chicago) 15:39:56 04/07/13 All info is here: - RonZ300 (Socal) 21:25:28 04/07/13 How many sqft did you use? (n/m) - Evan(CA) 22:02:19 04/07/13 Sorry, i dont remember... I think i got 2 rolls and had - RonZ300 (Socal) 01:59:29 04/08/13 Not really :) - Evan(CA) 03:46:33 04/08/13 I found this: - AHos(Chicago) 08:02:26 04/08/13 That all sounds great and yes, my estimates may be off as i - RonZ300 (Socal) 15:42:31 04/08/13 Good to know! - AHos(Chicago) 20:01:13 04/08/13 The MLV was thin, similar to dynamat, which is why i doubled - RonZ300 (Socal) 10:01:42 04/08/13 Did you do the floor as well? (n/m) - BigTDogg (MA) 09:18:34 04/08/13 You could look into RAAMMat Bxt II and a layer of ensolite - Drk93TT 19:49:21 04/07/13 Re: You could look into RAAMMat Bxt II and a layer of ensolite - AHos(Chicago) 21:30:32 04/07/13 Zeronoise.com has free shipping right now on Cascade - BigTDogg (MA) 20:56:26 04/07/13 B-Quiet.com is worth looking at (n/m) - scoops 22:52:44 04/07/13 Yes. I did a write-up (with photos) for my club newsletter - cherry 10:25:16 04/08/13 Nice work! (n/m) - BigTDogg (MA) 12:51:34 04/08/13 That was 35 sq ft?? - AHos(Chicago) 20:04:12 04/08/13 The photos don't show where all of the RAAMmat is installed. - cherry 08:56:57 04/09/13
Post a Followup	You cannot reply to this message because you are not logged in.