Subject	Re: You could look into RAAMMat Bxt II and a layer of ensolite
Posted by	AHos(Chicago) on April 07, 2013 at 9:30 PM
	This message has been viewed 420 times.
In Reply To	You could look into RAAMMat Bxt II and a layer of ensolite posted by Drk93TT on April 07, 2013 at 07:49 PM
Message	My only problem with ensolite is that it is a closed cell foam. Correct me if I'm wrong, but CCF isn't used to really keep noise out of the cabin. Rather, it's purpose is to dampen existing sound that is already in the cabin. I was thinking about putting a dynamat type of material under the MLV (like raammat), but that is used towards noise reduction due to rattling/vibrations - not my goal. Those are the reasons I chose MLV. I'm not sure if my above theories are correct, but from what I've been reading I think they are. I might go with a layer of CCF and MLV to get maximum dampening. I don't doubt that the combination you used reduced sound levels, but I think the MLV would be more efficient at reducing the sound level.
Follow Ups	Anyone have experience with mass loaded vinyl? - AHos(Chicago) 12:33:46 04/07/13 I did the entire back of my Z, double layer with aircraft - RonZ300 (Socal) 13:16:56 04/07/13 Where did you buy the material? - Evan(CA) 13:25:04 04/07/13 Re: I did the entire back of my Z, double layer with aircraft - AHos(Chicago) 15:05:57 04/07/13 Also, - AHos(Chicago) 15:39:56 04/07/13 All info is here: - RonZ300 (Socal) 21:25:28 04/07/13 How many sqft did you use? (n/m) - Evan(CA) 22:02:19 04/07/13 Sorry, i dont remember... I think i got 2 rolls and had - RonZ300 (Socal) 01:59:29 04/08/13 Not really :) - Evan(CA) 03:46:33 04/08/13 I found this: - AHos(Chicago) 08:02:26 04/08/13 That all sounds great and yes, my estimates may be off as i - RonZ300 (Socal) 15:42:31 04/08/13 Good to know! - AHos(Chicago) 20:01:13 04/08/13 The MLV was thin, similar to dynamat, which is why i doubled - RonZ300 (Socal) 10:01:42 04/08/13 Did you do the floor as well? (n/m) - BigTDogg (MA) 09:18:34 04/08/13 You could look into RAAMMat Bxt II and a layer of ensolite - Drk93TT 19:49:21 04/07/13 Re: You could look into RAAMMat Bxt II and a layer of ensolite - AHos(Chicago) 21:30:32 04/07/13 Zeronoise.com has free shipping right now on Cascade - BigTDogg (MA) 20:56:26 04/07/13 B-Quiet.com is worth looking at (n/m) - scoops 22:52:44 04/07/13 Yes. I did a write-up (with photos) for my club newsletter - cherry 10:25:16 04/08/13 Nice work! (n/m) - BigTDogg (MA) 12:51:34 04/08/13 That was 35 sq ft?? - AHos(Chicago) 20:04:12 04/08/13 The photos don't show where all of the RAAMmat is installed. - cherry 08:56:57 04/09/13
Post a Followup	You cannot reply to this message because you are not logged in.