Subject	Re: Re: So I went up to the shop today to try doing some work on the
Posted by	TurboTurtle (WaldorfMD) on April 06, 2013 at 9:41 PM
	This message has been viewed 262 times.
In Reply To	Re: So I went up to the shop today to try doing some work on the posted by ryzan on April 06, 2013 at 08:15 PM
Message	Check to make sure quarter panel is not stretched or damaged. It sounds like the striker as well as the screw holes are out of position. You can use a 2x4 and a hammer to re position the striker if the inner quarter is a little distorted. Try not to hit it to hard as it looks as if you only need a mild adjustment. http://jdmups.com/images/Vinyls/Turbo%20TURT.JPG
Follow Ups	So I went up to the shop today to try doing some work on the - ZpwrLab 19:50:16 04/06/13 Re: So I went up to the shop today to try doing some work on the - ryzan 20:15:25 04/06/13 Re: Re: So I went up to the shop today to try doing some work on the - TurboTurtle (WaldorfMD) 21:41:52 04/06/13 I bought the car from my cousin ad he took great care of it - ZpwrLab 10:45:38 04/07/13 as a last resort you can wallow the mounting holes for the - Zvil (FL) 22:12:22 04/06/13 Thank you, I just realized this on my Z the other day. Sucks (n/m) - ZinnZ32 14:12:10 04/07/13 I'd only adjust it when it was sitting on the ground, level. (n/m) - Multi_Read (CA) 13:09:00 04/07/13 It was like that at my cousin's place on flat ground to. (n/m) - ZpwrLab 14:17:01 04/07/13
Post a Followup	You cannot reply to this message because you are not logged in.