Subject	Re: you need a valve job
Posted by	wild_maxx on April 04, 2013 at 7:39 PM
	This message has been viewed 149 times.
In Reply To	you need a valve job posted by aliaZ on April 04, 2013 at 06:35 PM
Message	I'm assuming that I'll need a valve job but I'm going to have the machine shop make that call. I'd rather not replace all 12 valve seats if I can avoid it. At that point it will be more cost effective to replace the heads. I already bought 12 new intake valves though...
Follow Ups	Intake valves on TT heads... "30 vs 30P" - KongZTT GT28RS MD 21:48:12 04/03/13 Also,.. I have a good set of 95' NA heads here.. - KongZTT GT28RS MD 22:10:30 04/03/13 those are the bad valves - aliaZ 06:28:03 04/04/13 I'm confused by that statement. 30P == 30? Also, are the - evan_aggie 08:00:19 04/04/13 The bad VALVES are stamped "30" on the face (n/m) - ZXoltan 08:08:38 04/04/13 The other valves don't have "EG" stamped on them either. - evan_aggie 08:23:37 04/04/13 Judging by how flush those intake valves are sitting - Ashman2k2 08:50:48 04/04/13 agreed (n/m) - aliaZ 09:38:21 04/04/13 Just trying to learn: how are they supposed to look? They - evan_aggie 09:51:59 04/04/13 here - aliaZ 10:21:13 04/04/13 Re: here - wild_maxx 11:48:57 04/04/13 thanks to both of you for the pics and links. (n/m) - evan_aggie 12:44:49 04/04/13 did you have to cut new valve seats? - KongZTT GT28RS MD 18:05:17 04/04/13 haha. Lucky me. of course I would get the "rare" soft valves - KongZTT GT28RS MD 18:06:14 04/04/13 you need a valve job - aliaZ 18:35:48 04/04/13 Re: you need a valve job - wild_maxx 19:39:28 04/04/13 yep.. going to go ahead and get the full job done.. - KongZTT GT28RS MD 15:11:38 04/05/13
Post a Followup	You cannot reply to this message because you are not logged in.