TwinTurbo.NET: Nissan 300ZX forum - i replaced
People Seeking Info
 
   


     
Subject i replaced
     
Posted by March.Prince on April 03, 2013 at 4:42 PM
  This message has been viewed 194 times.
     
In Reply To need help, i am looking for best price/ performance on posted by DJ2_300zxLover on April 03, 2013 at 03:02 PM
     
Message My front lower control arms as well as the tension rods with ES bushings. I later found this out;

Posted by- Evan(CA)

I was looking to pick up a set for my bros Z as a cheap fix and this is the response I got from Greg D.
"The ES hold the rod too tight and cause the lower control arm to stress and flex that I have seen break a number of lower control arms. ES did make a change to the bushing, but they are still keeping the rod from being able to twist in the direction of movement needed. I will not sell or install ES bushings."

I think the general consensus is to use the pillow ball. though i could be wrong.

I havent had any problems with my ES bushings yet... but who knows. Just some food for thought.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.