Subject	car bounced on launch and a few hops were...
Posted by	wickdGSXR on April 01, 2013 at 12:03 PM
	This message has been viewed 140 times.
In Reply To	Re: first 1/4 mile run...the nephew's video (link) posted by imelmo on April 01, 2013 at 07:07 AM
Message	too much for the aluminum driveshaft. I just looked under my car and realized I installed SpecialtyZ subframe spacers already (it's been at least a decade since I did it). The car does NOT have solid aluminum rear differential bushings. I am worried that solid aluminum differential bushings will not be enough. Another member mentioned SPL HICAS eliminator instead of my current Stillen. Horsepower is nothing if you can't get the power on the ground,
Follow Ups	first 1/4 mile run...the nephew's video (link) - wickdGSXR 01:13:22 04/01/13 Re: first 1/4 mile run...the nephew's video (link) - imelmo 07:07:35 04/01/13 car bounced on launch and a few hops were... - wickdGSXR 12:03:12 04/01/13 LOL... - BradX (UF) 13:27:28 04/01/13 I tried to explain the 2 lights..but he ignored me. (n/m) - wickdGSXR 14:06:53 04/01/13 wow that was on repeat for a while - fuzzymonkey 14:47:21 04/01/13 upon inspection, rear subframe bushings a spewing rubber. (n/m) - wickdGSXR 15:51:50 04/01/13 And this is why spacers are wrong answer. (n/m) - BlackholeZ 03:38:37 04/02/13 buying subframe with SPL subframe bushings and.. - wickdGSXR 10:29:24 04/02/13 With the right tools it can be easier - BlackholeZ 11:44:31 04/02/13
Post a Followup	You cannot reply to this message because you are not logged in.