Subject	will order them tomorrow...what else?
Posted by	wickdGSXR on March 31, 2013 at 11:53 AM
	This message has been viewed 166 times.
In Reply To	solid aluminum ones. not sure if SPL still sells them, but posted by genic on March 31, 2013 at 10:13 AM
Message	If I have to pull the whole subframe, can you recommend any other busihings to replace on the rear end/suspension? I found this post from Greg Dupree: The loose mounted subframe is the largest contributor. Anything loose in the rear will cause wheel hop. The most common overlooked worn part in the rear are the hicas inner tie rods. I would say 8 out of every 10 cars that come in have bad rear inner tie rods. Also check the shocks ,like already has been suggested. I installed the HICS eliminator from Stillen years ago. Do I need to worry about this? I'm about to learn a whole lot about suspension.
Follow Ups	first time running the quarter mile and... - wickdGSXR 09:37:59 03/31/13 You need subframe spacers. (n/m) - TriniTT 09:41:34 03/31/13 or do it right and do bushings (n/m) - BlackholeZ 09:44:35 03/31/13 solid aluminum ones. not sure if SPL still sells them, but - genic 10:13:04 03/31/13 Re: solid aluminum ones. not sure if SPL still sells them, but - wickdGSXR 10:33:20 03/31/13 you wont need the spacers if you replace all the bushings - genic 11:11:43 03/31/13 will order them tomorrow...what else? - wickdGSXR 11:53:02 03/31/13 Stillen hicas eliminator still uses oem inner tie rods. (n/m) - Evan_Wright (Ca) 13:00:14 03/31/13 If you have the money - AHos(Chicago) 13:55:49 03/31/13 I will check it out..thank you (n/m) - wickdGSXR 23:32:47 03/31/13 Solid aluminum are pretty intense, - TriniTT 14:34:29 03/31/13 Re: Solid aluminum are pretty intense, - wickdGSXR 23:35:19 03/31/13 Whiteline subframe bushings are a better solution IMHO (n/m) - aliaZ 12:02:15 03/31/13 I prefer spacers if the original bushing is fine. - TriniTT 14:26:28 03/31/13 it was a Powertrain aluminum driveshaft I snapped :( (n/m) - wickdGSXR 10:41:13 03/31/13
Post a Followup	You cannot reply to this message because you are not logged in.