Subject	you wont need the spacers if you replace all the bushings
Posted by	genic on March 31, 2013 at 11:11 AM
	This message has been viewed 159 times.
In Reply To	Re: solid aluminum ones. not sure if SPL still sells them, but posted by wickdGSXR on March 31, 2013 at 10:33 AM
Message	with solid ones. imo, do all solid, and not mix solid and spacers. only thing is...you have to drop the whole rear subframe to install them. ...tip, once you get the old bushings out, but the solid bushings in the freezer for a while (so they shrink just a tad) ... and they should just slide right in without much hassle.
Follow Ups	first time running the quarter mile and... - wickdGSXR 09:37:59 03/31/13 You need subframe spacers. (n/m) - TriniTT 09:41:34 03/31/13 or do it right and do bushings (n/m) - BlackholeZ 09:44:35 03/31/13 solid aluminum ones. not sure if SPL still sells them, but - genic 10:13:04 03/31/13 Re: solid aluminum ones. not sure if SPL still sells them, but - wickdGSXR 10:33:20 03/31/13 you wont need the spacers if you replace all the bushings - genic 11:11:43 03/31/13 will order them tomorrow...what else? - wickdGSXR 11:53:02 03/31/13 Stillen hicas eliminator still uses oem inner tie rods. (n/m) - Evan_Wright (Ca) 13:00:14 03/31/13 If you have the money - AHos(Chicago) 13:55:49 03/31/13 I will check it out..thank you (n/m) - wickdGSXR 23:32:47 03/31/13 Solid aluminum are pretty intense, - TriniTT 14:34:29 03/31/13 Re: Solid aluminum are pretty intense, - wickdGSXR 23:35:19 03/31/13 Whiteline subframe bushings are a better solution IMHO (n/m) - aliaZ 12:02:15 03/31/13 I prefer spacers if the original bushing is fine. - TriniTT 14:26:28 03/31/13 it was a Powertrain aluminum driveshaft I snapped :( (n/m) - wickdGSXR 10:41:13 03/31/13
Post a Followup	You cannot reply to this message because you are not logged in.