TwinTurbo.NET: Nissan 300ZX forum - i never saw the point of this
Subject
i never saw the point of this
Posted by
fuzzymonkey
on March 28, 2013 at 12:29 PM
This message has been viewed
150
times.
In Reply To
I deleted the brace when I installed my SZ 3". (n/m)
posted by SilverZXTT(CO)
on March 28, 2013 at 12:17 PM
Message
what? in case 2 studs break and it's hanging from the rear hangers? uhhh...
Follow Ups
Exhaust Brace??
-
AddictedToBoost
03:23:32 03/28/13
What Exhaust? There shouldn't be any clearance issues. (n/m)
-
Evan(CA)
03:33:30 03/28/13
Re: What Exhaust? There shouldn't be any clearance issues.
-
AddictedToBoost
08:40:28 03/28/13
Re: Re: What Exhaust? There shouldn't be any clearance issues.
-
AddictedToBoost
09:02:40 03/28/13
You can space it out with exhaust manifold washers. (n/m)
-
michaell32 (FL)
07:52:56 03/28/13
Re: You can space it out with exhaust manifold washers.
-
AddictedToBoost
08:46:04 03/28/13
You are assuming incorrectly. It has everything to do
-
Bernie (NoVA)
13:28:57 03/28/13
this is the correct answer
-
aliaZ
08:23:48 03/29/13
I deleted the brace when I installed my SZ 3". (n/m)
-
SilverZXTT(CO)
12:17:04 03/28/13
i never saw the point of this -
fuzzymonkey
12:29:54 03/28/13
Its there to box in the trans tunnel - removing it may
-
Bernie (NoVA)
13:27:09 03/28/13
^^Absolutely correct...just did this per Bernie's guidance! (n/m)
-
MikeD (Philly)
15:13:07 03/28/13
Re: ^^Absolutely correct...just did this per Bernie's guidance!
-
AddictedToBoost
19:47:42 03/28/13
^^this
-
BlackholeZ
20:37:37 03/28/13
Re: ^^this
-
AddictedToBoost
21:00:18 03/28/13
no, mine cleared
-
BlackholeZ
02:01:48 03/29/13
do you have all of your hangers installed?
-
BoneZ (MD)
18:53:56 03/28/13
Re: do you have all of your hangers installed?
-
AddictedToBoost
19:38:48 03/28/13
A little bit up front counts for a lot in the back..
-
BoneZ (MD)
06:02:16 03/29/13
Re: A little bit up front counts for a lot in the back..
-
AddictedToBoost
10:04:22 03/29/13
yes (n/m)
-
Adam (NoVA)
17:28:20 03/29/13
Post a
Followup
You cannot reply to this message because you are not
logged in
.