Subject	I wouldn't worry about the compression being raised. I am
Posted by	MixManMash on March 24, 2013 at 1:20 PM
	This message has been viewed 203 times.
In Reply To	.. I have late style bde intake and bde "bullseye" exhaust posted by KongZTT GT28RS MD on March 24, 2013 at 09:09 AM
Message	using a stock head gasket and my compression ratio is around 10:1. Not sure about the answers to the rest of your questions.
Follow Ups	Head and Block resurfacing/decking.. - KongZTT GT28RS MD 07:57:29 03/24/13 I think the max amount is due to non-adjustable timing - aliaZ 08:33:22 03/24/13 Yup. Just have to get adjustable cam gears to compensate. - MixManMash 08:42:13 03/24/13 .. I have late style bde intake and bde "bullseye" exhaust - KongZTT GT28RS MD 09:09:39 03/24/13 GregD told me they reuse stock head stud/bolts alot - z-u-later 12:30:31 03/24/13 Yea I have heard of others doing it.. But screw that.. - KongZTT GT28RS MD 12:38:20 03/24/13 There was a topic on 3ZC that covered this... the FSM - PiotrC70 13:37:04 03/24/13 I wouldn't worry about the compression being raised. I am - MixManMash 13:20:40 03/24/13 Hey hold up don't you need a degree your cams first - 93 Blue Z32(NC) 12:54:37 03/24/13 Not from what Greg told me. They adjust one cam gear at a - MixManMash 13:17:28 03/24/13 Put a machinist's level on the heads, use a feeler gage per. - ZaXxon 09:00:59 03/24/13 If the cylinder heads are from an engine that - ZXRider 11:51:58 03/24/13 Yea I don't know the absolute history of these heads. - KongZTT GT28RS MD 12:29:21 03/24/13
Post a Followup	You cannot reply to this message because you are not logged in.