Subject	My tip for you:
Posted by	FuerGrissa on March 16, 2013 at 9:15 PM
	This message has been viewed 220 times.
In Reply To	For the welders here, welding body sheet metal: posted by Jkova300z on March 16, 2013 at 04:18 PM
Message	Is to clean out the inside of the core support as well as possible and then do it again. Mine was full of oily sludge and I had no end of trouble with contamination. I was using a tig though, so no advice on your machine setup.
Follow Ups	For the welders here, welding body sheet metal: - Jkova300z 16:18:24 03/16/13 I'm no expert but... - Shiers69 18:30:48 03/16/13 Sounds good. - Jkova300z 18:51:54 03/16/13 +1 all great advice! - Jayru 08:28:08 03/18/13 My tip for you: - FuerGrissa 21:15:49 03/16/13 Yea, I did heavy cleaning with brake clean followed by prep, - Jkova300z 23:19:40 03/16/13 Watch out using brake cleaner before welding, see this: - ttsmokin 13:53:17 03/17/13 Ah yes.. I remember reading something about this before.. - KongZTT GT28RS MD 18:00:28 03/17/13 The same goes for the galvanized coating on the Z - Jayru 08:15:29 03/18/13 I have that same welder.. It's a great one.. - KongZTT GT28RS MD 09:16:39 03/17/13
Post a Followup	You cannot reply to this message because you are not logged in.