Subject	Sounds good.
Posted by	Jkova300z on March 16, 2013 at 6:51 PM
	This message has been viewed 188 times.
In Reply To	I'm no expert but... posted by Shiers69 on March 16, 2013 at 06:30 PM
Message	I tried a few spots with the .030 and it was hard to weld on lower voltage, so that .024 sound like the way to go. Thanks.
Follow Ups	For the welders here, welding body sheet metal: - Jkova300z 16:18:24 03/16/13 I'm no expert but... - Shiers69 18:30:48 03/16/13 Sounds good. - Jkova300z 18:51:54 03/16/13 +1 all great advice! - Jayru 08:28:08 03/18/13 My tip for you: - FuerGrissa 21:15:49 03/16/13 Yea, I did heavy cleaning with brake clean followed by prep, - Jkova300z 23:19:40 03/16/13 Watch out using brake cleaner before welding, see this: - ttsmokin 13:53:17 03/17/13 Ah yes.. I remember reading something about this before.. - KongZTT GT28RS MD 18:00:28 03/17/13 The same goes for the galvanized coating on the Z - Jayru 08:15:29 03/18/13 I have that same welder.. It's a great one.. - KongZTT GT28RS MD 09:16:39 03/17/13
Post a Followup	You cannot reply to this message because you are not logged in.