Subject	For the welders here, welding body sheet metal:
Posted by	Jkova300z on March 16, 2013 at 4:18 PM
	This message has been viewed 332 times.
Message	I have a Hobart 140 MIG. Welding up my front rad support. What setup would you recommend for this type of thin gauge stuff? I'm running .030" wire in it now, with argon/co2 in the tank. Thinking I should use .024" to keep from burning through. What would be recommended?
Follow Ups	For the welders here, welding body sheet metal: - Jkova300z 16:18:24 03/16/13 I'm no expert but... - Shiers69 18:30:48 03/16/13 Sounds good. - Jkova300z 18:51:54 03/16/13 +1 all great advice! - Jayru 08:28:08 03/18/13 My tip for you: - FuerGrissa 21:15:49 03/16/13 Yea, I did heavy cleaning with brake clean followed by prep, - Jkova300z 23:19:40 03/16/13 Watch out using brake cleaner before welding, see this: - ttsmokin 13:53:17 03/17/13 Ah yes.. I remember reading something about this before.. - KongZTT GT28RS MD 18:00:28 03/17/13 The same goes for the galvanized coating on the Z - Jayru 08:15:29 03/18/13 I have that same welder.. It's a great one.. - KongZTT GT28RS MD 09:16:39 03/17/13
Post a Followup	You cannot reply to this message because you are not logged in.