Subject	Curious. Why do you want to switch your throttle bodies?
Posted by	michaell32 (FL) on March 14, 2013 at 12:04 PM
	This message has been viewed 166 times.
In Reply To	Now I just need to figure out why I have such a strong smell posted by Evan_Wright (Ca) on March 14, 2013 at 11:54 AM
Message	You already spent the money so why change it for 2mm. I went stanza from the start but if I bought the z1 tb I wouldnt change. RobZ can also port out the z1s to 61 mm and repair the problem where some of them stick. KongZTT GT28RS MD "I was very impressed with his mother mounts" According to AMS duplication = innovation
Follow Ups	Finally resolved a hesitation under heavy load issue. - Evan_Wright (Ca) 09:22:15 03/14/13 The EIX series ngk is suppose to be one of the most - TTZ2NV(EPTmotorsports) 09:42:12 03/14/13 Picked em up. Thanks! (n/m) - Antihero 11:04:27 03/14/13 hmmm - LJZTT 11:11:05 03/14/13 I had plans to check all kinds of things...most of which - Evan_Wright (Ca) 11:49:23 03/14/13 those plugs don't look long enough - moxie (SF) 11:21:14 03/14/13 check this out: - Antihero 11:30:28 03/14/13 Ok great thanks! i have 10k on my plugs and have trying to - Hydrus 14:27:05 03/14/13 I wonder what Greg found out after aliaZ sent him his plug. (n/m) - DVDBURN (MD) 17:29:10 03/14/13 That's because Antihero picked up a set^^^ (n/m) - Evan_Wright (Ca) 11:42:09 03/14/13 You had a defective plug then... The PFR6B-11B's are good - Ash's Z 11:53:56 03/14/13 I agree that the pfr6b-11bs are fine for my setup. They - Evan_Wright (Ca) 11:58:44 03/14/13 Now I just need to figure out why I have such a strong smell - Evan_Wright (Ca) 11:54:11 03/14/13 Curious. Why do you want to switch your throttle bodies? - michaell32 (FL) 12:04:14 03/14/13 They have a few characteristics to them that I don't care - Evan_Wright (Ca) 12:15:28 03/14/13 I understand. Those reasons are why I chose the stanzas. - michaell32 (FL) 12:43:02 03/14/13 Here are a few links that helped me doing the conversion. - michaell32 (FL) 15:09:15 03/14/13 Thanks. I'm planning on slotting the bolt holes like the guy - Evan_Wright (Ca) 15:18:05 03/14/13 Thats how I did it after reading a post by Ash a while back. - michaell32 (FL) 15:57:07 03/14/13 This happens on mine sometimes, and on my old 280zxt too - MegamanMk2 13:38:16 03/14/13 I wonder if it is because the coolant overflow tank has - MixManMash 14:54:25 03/14/13 I too have hesitation but only on start up & and also poor - Hydrus 13:53:26 03/14/13 They are shorter. See the link Antihero posted above for - Evan_Wright (Ca) 14:10:15 03/14/13 switched to EIX's a couple years ago... - vorpalZ 14:08:38 03/14/13 To Ash's point, did the new plugs affect your idle adversely - Haasz32 14:38:09 03/14/13 Not that I have seen on any Z's in our area running them. (n/m) - MixManMash 14:56:37 03/14/13 I should add, if they have been tuned. Sometimes Z32s - MixManMash 14:57:43 03/14/13 no change in idle or fuel economy that was noticeable - vorpalZ 15:25:15 03/14/13 I feel your pain on the truck mpg's. My '05 F150 5.4L only - Haasz32 08:02:52 03/15/13 The problem is, the Frontier isn't much better than a full - MixManMash 22:35:32 03/15/13 Thanks for this post! I have been fighting this same issue! (n/m) - Josh91CRPTT 14:08:57 03/14/13 Just purchased mine from amazon! I think there are 7 left. - Josh91CRPTT 18:44:26 03/14/13 I think this is a good resource. - Tanley 15:49:18 03/14/13 I wouldnt use that as a "resource" - ZXoltan 16:58:39 03/14/13 Granted the descriptions are generalized. - Tanley 21:28:09 03/14/13 Nice. (n/m) - DVDBURN (MD) 17:27:04 03/14/13
Post a Followup	You cannot reply to this message because you are not logged in.