Subject	Re: Non U.S. side fender signal hole locations
Posted by	MegaZ on March 08, 2013 at 5:42 PM
	This message has been viewed 187 times.
In Reply To	Non U.S. side fender signal hole locations posted by BOOZT_JUNKIE on March 08, 2013 at 12:57 PM
Message	I cut my fenders myself. The tops of the signals are 7.5" from the hood/fender gap and the trailing edges 5" from the door/fender gap. You can determine the shape of the hole by the shape of the parts that are below flush, taking into account that the forward tabs flex backward and snap in to hold the signal in place. Don't go any lower on the fender than I did because the unibody is back there. If I had tried to mount any lower, there would not have been room. Stage XII 1991 Z32TT
Follow Ups	Non U.S. side fender signal hole locations - BOOZT_JUNKIE 12:57:25 03/08/13 Someone should whip up some stencils for this (n/m) - Shiers69 14:11:34 03/08/13 sure, just as soon as I swap my speedo and odo over to KPH (n/m) - LJZTT 05:18:20 03/09/13 Re: Non U.S. side fender signal hole locations - MegaZ 17:42:59 03/08/13 Re: Re: Non U.S. side fender signal hole locations - MikeC(NZ) 19:34:43 03/08/13 I have real Japanese jdm fenders I could make - Nis300owner 23:38:33 03/08/13 I'm covering mine up and you guys are putting them in. - LivinTheDream 19:49:42 03/08/13 "you guys" nothing (n/m) - LJZTT 09:24:08 03/09/13 They look terrible. (n/m) - Bernie (NoVA) 08:33:36 03/09/13 2nd. (n/m) - Evan(CA) 22:57:16 03/09/13
Post a Followup	You cannot reply to this message because you are not logged in.