Subject	Non U.S. side fender signal hole locations
Posted by	BOOZT_JUNKIE on March 08, 2013 at 12:57 PM
	This message has been viewed 323 times.
Message	Does anyone have a set of the factory fenders where the holes are pre-cut for the fender indicators where they could give me some measurements please? I have searched high and low on every forum, especially here and on google. Pretty much all the info i got was from Nico "eyeball it and wire them into the front signals." I understand the wiring part, as they only blink, not stay lit up, but i would like to put the holes as close to the OEM location as possible. Any info/pics/measurements would be super helpful. Thanks
Follow Ups	Non U.S. side fender signal hole locations - BOOZT_JUNKIE 12:57:25 03/08/13 Someone should whip up some stencils for this (n/m) - Shiers69 14:11:34 03/08/13 sure, just as soon as I swap my speedo and odo over to KPH (n/m) - LJZTT 05:18:20 03/09/13 Re: Non U.S. side fender signal hole locations - MegaZ 17:42:59 03/08/13 Re: Re: Non U.S. side fender signal hole locations - MikeC(NZ) 19:34:43 03/08/13 I have real Japanese jdm fenders I could make - Nis300owner 23:38:33 03/08/13 I'm covering mine up and you guys are putting them in. - LivinTheDream 19:49:42 03/08/13 "you guys" nothing (n/m) - LJZTT 09:24:08 03/09/13 They look terrible. (n/m) - Bernie (NoVA) 08:33:36 03/09/13 2nd. (n/m) - Evan(CA) 22:57:16 03/09/13
Post a Followup	You cannot reply to this message because you are not logged in.