Subject	I tried that first and wasn't happy with the results.
Posted by	Evan(CA) on March 02, 2013 at 12:14 AM
	This message has been viewed 166 times.
In Reply To	I used plasti-dip. posted by Stokens (AR) on March 01, 2013 at 11:31 PM
Message	430 dollars later I have some new door and window moldings installed in a box on my closet floor :) At least I can finally use the new t-top hook finisher I've been saving for years.
Follow Ups	Can these moldings be replaced without removing the glass? - Evan(CA) 20:41:04 03/01/13 Re: Can these moldings be replaced without removing the glass? - Xteam300TT (South Tx ) 20:48:58 03/01/13 Yes (n/m) - njz 20:57:46 03/01/13 Not usually - they stick to the glass seal urethane. - Bernie (NoVA) 20:57:55 03/01/13 I removed the side/lower molding on my tt. - smartone 00:05:07 03/02/13 So the entire hatch seal can be replaced? - Evan(CA) 00:17:53 03/02/13 So just talked to the paint guy (my dad)... - smartone 16:16:50 03/02/13 FYI - for the rear window molding, I taped everything up - jzack 23:05:09 03/01/13 I used plasti-dip. - Stokens (AR) 23:31:06 03/01/13 I tried that first and wasn't happy with the results. - Evan(CA) 00:14:42 03/02/13 Neither of them are that bad. - Evan(CA) 00:12:46 03/02/13 Yes, it can be done as long as you're careful removing them. - ZXoltan 05:34:08 03/02/13 you can 3M vinyl it.. should come out good.. (n/m) - DJ2_300zxLover 14:57:06 03/02/13 Re: Can these moldings be replaced without removing the glass? - coolcesitar 16:53:55 03/02/13 Got a pic of th rear hatch glass without the molding? - Evan(CA) 17:50:16 03/02/13
Post a Followup	You cannot reply to this message because you are not logged in.