Subject	yes, I followed instructions and loose-bolted the diffuser
Posted by	vorpalZ on February 25, 2013 at 1:52 PM
	This message has been viewed 236 times.
In Reply To	Did you remove the rear bumper? posted by Evan(CA) on February 25, 2013 at 01:45 PM
Message	to the new bumper cover and then installed on the car. Everything else lines up, all the push fasteners and lower bolts. Just can't get it up and over the license plate edge, as the two moulded inner stobols are preventing it from sliding in place. Looks OK in this config, I just wanted to check before I tackle the 'vert. Thanks, MY Zs ARE HYBRID VEHICLES, THEY RUN ON GASOLINE AND MONEY "I expressed no attitude, I'm correcting you. If you don't like it, try not to be wrong next time. Now you're getting attitude, and if you don't like that you should grow a thicker skin.” - TriniTT 14:04:16 12/22/12 ”Exhaust doesn't produce horsepower” - VERTTZ 13:17:22 06/26/12 I'm off to wax mine and go for a drive now. - BigTDogg (MA) 07:17:08 07/17/09 times change, people change, but the Z32 still kicks ass. - apudapus 16:46:02 06/15/07 I was more wondering how you set your climate control to 22* lol, it would be that fastest freezer on wheels! - Briscoe'sZ32 (NJ) 23:15:44 02/05/07 You have *got* to be getting a cut from B&B :D - SeedyROM 15:24:29 08/16/06 What do you think B&B stands for? - YugoBernie (NoVA) 15:57:09 08/16/06
Follow Ups	One down, vert to go... - vorpalZ 13:25:59 02/25/13 Did you remove the rear bumper? - Evan(CA) 13:45:29 02/25/13 yes, I followed instructions and loose-bolted the diffuser - vorpalZ 13:52:42 02/25/13 I don't think the bottom part is intended to hang that low (n/m) - BigTDogg (MA) 13:52:26 02/25/13 The brackets used to hold that section up may be backwards - ZinnZ32 14:00:07 02/25/13 yup, that looks like what I did... D'oh! (n/m) - vorpalZ 14:34:30 02/25/13 Sorry for not replying sooner. We haven't checked that email - TheTwinZ (Peru) 17:56:13 02/25/13
Post a Followup	You cannot reply to this message because you are not logged in.