Subject	I would recommend OEM over cometic.
Posted by	michaell32 (FL) on February 23, 2013 at 1:49 PM
	This message has been viewed 107 times.
In Reply To	I am just going to do cometic head gaskets (n/m) posted by ZxMoslowxZ on February 23, 2013 at 12:49 PM
Message	The cometic gasket arent bad but the block and heads have to be perfectly flat for it to work. The OEM gaskets are very good. Specialty Z has over 800hp and use OEM gaskets. According to AMS duplication = innovation
Follow Ups	Cp Pistons 87.5mm - ZxMoslowxZ 10:13:21 02/21/13 The machine shop will need the pistons and the block. - michaell32 (FL) 10:20:10 02/21/13 Ok sweet. - ZxMoslowxZ 10:42:52 02/21/13 Would you use an OEM head gasket with a .020 bore? - Sjpco07 01:07:53 02/22/13 Yes. OEM can accommodate 88 mm, maybe larger (n/m) - ZXoltan 07:11:42 02/22/13 I am just going to do cometic head gaskets (n/m) - ZxMoslowxZ 12:49:53 02/23/13 I would recommend OEM over cometic. - michaell32 (FL) 13:49:54 02/23/13
Post a Followup	You cannot reply to this message because you are not logged in.